Mitsubishi Electric Melsec Q Series User Manual page 99

4
SETTINGS AND PROCEDURE TO OPERATION
4.2 Settings and Procedure to Operation
This section explains the schematic procedure up to operation for using the MES interface
function.
(1) Starting the server computer
Procedure to operation
Database server computer
Install the relational database
and design the table.
Section 2.6.4 Precautions for
using database
Set ODBC for the database.
Section 8.2 Setting ODBC to the
Database
Install DB Connection Service and DB
Connection Service Setting Tool.
Section 5.1 Installation
Change the settings of DB Connection
Service.
Section 8.5 Setting Items of DB
Connection Service Setting Tool
Operation
Start the server computer, and then the MES interface module.
(2) Starting the MES interface module
Server computer/SNTP server computer
*1 Application server computer
*4
Create a user program.
Create an account for user program
execution.
Install DB Connection Service and DB
Connection Service Setting Tool.
Section 5.1 Installation
Change the settings of DB Connection
Service.
Section 8.5 Setting Items of DB
Connection Service Setting Tool
Figure 4.1 Server computer start-up procedure
*1 Be sure to make the settings to use the DB interface function.
Section 6.1 DB Interface Function
*2 Make the settings when using the program execution function.
Section 6.1.9 Program execution function
*3 Start it when using the SNTP server computer time with time synchronization function.
Section 6.3 Time Synchronization Function
*4 Restart a personal computer after installing the relational database.
If not, communication with the MES interface module may be impossible.
*5 Log on to the application server computer with the created account for user program execution
once before using the program execution function.
When using the application server computer to which the program execution function is set, log on
with an account other than the created account for user program execution.
*2
*5
4.2 Settings and Procedure to Operation
SNTP server computer *3
Start the SNTP server.
4
1
2
3
4
5
6
7
8
- 2