Panasonic AK-HRP200G Operating Instructions Manual page 17

Parts and their functions (when operating a studio handy camera)
2) Press the lit DATA SET button <UP><DOWN>.
Press the lit DATA SET button <UP><DOWN> to select a
camera number.
3) Press the camera select button <SELECT>.
The camera select button <SELECT> turns off and the control
privileges are enabled. IRIS/M.PED is disabled.
<Note>
If the camera select button continues to flash when a camera is
selected by pressing the camera select button, a connection has not
been established. Check the settings of the camera assigned to the
camera number.
z Caution when multiple ROPs are connected
When multiple ROPs are connected to one CCU with IP
connections, operation will be possible only using the one ROP
with the control privileges enabled. (The camera select button
<SELECT> of the ROP with the control privileges enabled will be
on.) The camera select buttons <SELECT> of the other ROPs will
be flashing and operation for cameras will not be possible because
the control privileges are disabled. If you press the camera select
button <SELECT> while it is flashing, the control privileges will be
enabled and operation will be possible on the ROP of the button
that was pressed. The camera select button <SELECT> will turn
off. If you press the camera select button <SELECT> again, the
camera select button <SELECT> will turn on and IRIS/M.PED
will be enabled as well. At that time, the camera select buttons
<SELECT> of other ROPs will flash and operation will be no
longer possible.
Up to three ROPs can be connected to one CCU. From the fourth
ROP, the camera select button <SELECT> will be off and the
control privileges will be disabled.
(continued)
17