Connecting To A Camera Recorder - Panasonic AK-HRP200G Operating Instructions Manual

System connection diagram

Connecting to a camera recorder

„ IP connection
„
<Note>
To determine whether a camera recorder can be connected using IP connection, please see the Operating Instructions for the camera recorder or visit
the following Web site.
http://pro-av.panasonic.net/
VARICAM
1.
Connect the IP connector <LAN> of this unit and LAN
connector on the camera recorder with a LAN cable
(option).
• When connecting via a switching hub (100base-TX), use a straight
cable (category 5 or better shielded cable) for the LAN cable. When
not connecting via a switching hub, use a cross cable (category 5 or
better shielded cable) for the LAN cable.
(continued)
AJ-PX***
LAN cable
(straight cable)
External DC
power supply
AJ-PX***
LAN cable
(straight cable)
Switching hub
(100base-TX)
LAN cable
(straight cable),
up to 100 m
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
AK-HRP200
2.
When you have finished connecting the equipment, turn
on the power of the camera and turn on the external DC
power supply of the unit.
<Note>
• Up to 19 camera recorders and remote cameras can be controlled
from this unit.
• To use a remote camera via an IP connection, you need to configure
the settings with ROP Setup Software (accessory). Please make sure
that the version of the ROP setup software is Ver. 3.0.0.0 or higher.
Before using ROP Setup Software, connect the unit to the personal
computer with a LAN cable.
• With IP connections, the unit can coexist with a CCU. For how to
connect to a CCU via an IP connection, refer to (→page 36).
• For details on the settings for IP connections, refer to Operations and
Settings on the supplied CD-ROM.Please refer to the latest Operating
Instructions at the following Web site.
http://panasonic.biz/sav/manual/index.html
*
1
Please visit the following Web site for the latest software information.
http://pro-av.panasonic.net/
Personal computer
*
1
41