Panasonic AK-HRP200G Operating Instructions Manual page 37

System connection diagram
„ Serial connection (AK-HC1500)
„
AK-HC1500
Dedicated cable
(prepare on site)
External DC
power supply
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
AK-HRP200
Cable specifications
8 - - - - - -1
Modular
Connector
RJ-45 Modular Connector
8-pin Socket
8-pin Plug
CAT-5: Male
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
AK-HRP200
(continued)
Interface connector
AW-PS550 (option)
Cable to prepare (up to 1,000 m)
D-Sub 15-pin: Male
Connector: DHW10-153F200
(Advanced Connector Inc.)
Cover: DE-C8-J9-F5-1R
(Japan Aviation Electronics
Industry, Ltd.)
GND 1
--- 2
TX_C 3
RX_C 4
RX_H 5
TX_H 6
--- 7
--- 8
10
To power unit 11
(AW-PS550 DC12V)
12
13
14
15
1.
Connect the RS-422 connector <RS-422> of the unit and
the interface connector of AK-HC1500 with a dedicated
cable.
• For the cable specifications, refer to the following diagram.
2.
When you have finished connecting the equipment, turn
on the power of the camera and the power of the unit.
<Note>
Set the communication protocol of AK-HC1500 to "PROTCOL3"
(convertible PC control protocol).
Make sure you configure the setting on the cameras individually before
installation.
1 G/L GND
2 TC IN
3 CAM_MP
4 TX_C(EIA422)
5 RX_C(EIA422)
6 +12V IN
7 G/L IN
8 GND
9 TX_H(EIA422)
RX_H(EIA422)
GND
TC GND
GND
GND
GND
AW-PS550 (option)
AK-HC1500
37