Panasonic AK-HRP200G Operating Instructions Manual page 40

System connection diagram
„ IP connection (AW-HE50/AW-HE60/AW-HE120)
„
AW-HE50/AW-HE60
1.
Connect the IP connector <LAN> of the unit and LAN
connector of the camera (AW-HE50/AW-HE60/AW-HE120)
with a LAN cable (option).
• When connecting via a switching hub (100base-TX), use a straight
cable (category 5 or better shielded cable) for the LAN cable. When
not connecting via a switching hub, use a cross cable (category 5 or
better shielded cable) for the LAN cable.
40
(continued)
AW-HE120
Supplied AC adapter
LAN cable
(straight cable)
Switching hub
(100base-TX)
External DC
power supply
12V IN
AK-HRP200
Personal computer
Supplied AC adapter
LAN cable
(straight cable)
LAN cable
(straight cable),
up to 100 m
LAN RS-422 PREVIEW
CCU
SIGNAL GND
2.
When you have finished connecting the equipment, turn
on the power of the camera and turn on the external DC
power supply of the unit.
<Note>
• Up to 19 cameras (AW-HE50/AW-HE60/AW-HE120) can be controlled
from the unit.
• To use a remote camera via an IP connection, you need to configure
the settings with ROP Setup Software (accessory). Before using ROP
Setup Software, connect the unit to the personal computer with a LAN
cable.
• With IP connections, the unit can coexist with a CCU. For how to
connect to a CCU via an IP connection, refer to (→page 36).
• For details on the settings for IP connections, refer to Operations and
Settings on the supplied CD-ROM.