Process Sequence window*
CAUTION
To avoid having quality control data reported for the wrong tests,
Process Sequence numbers
results are also affected.
Use this window to set the order in which:
•
tests display at windows such as Order Entry, Test Select, and Real-Time QC
•
tests print
Only tests set up in the windows listed below can be arranged at the Process Sequence
window:
•
System Test List
•
Analytical Parameters (Serum)
•
ISE Parameter Settings
•
Ratio Parameters
Ratio Parameters window*
Use this window to create up to 20 ratios with two test items in each. The ratio can
contain 2 tests.
Contamination Settings window*
Use this window to set the conditions for preventing contamination of reagent probes and
reaction tray cuvettes.
Each condition specifies an action to be taken if a specific interferer contaminates a
specific receptor. You can set up to 100 conditions each for reagent probes and RRV
cuvettes.
Perform any of the following tasks at this window:
•
set conditions for avoiding reagent probe contamination
•
set conditions for avoiding RRV cuvette contamination
•
set conditions for anti-contamination detergent
•
print the conditions
•
clear the conditions
Ctrl/Cal Sample Setup window*
Perform any of the following tasks at this window:
•
get or view measurement times, container types and comments for control and
calibration samples
The settings are available in the Calibration Setup, QC Sample Definition, and ISE
Parameter Settings windows for entering sample tray information.
•
determine the tests set to run on a given position.
System Overview
after control results have been accumulated. Patient
do not switch
57