Siemens SINAMICS S120 Equipment Manual page 200

DC link components
5.1 Braking Module
Installing the Braking Module
Note
To install a frame size GX Braking Module in a frame size GB Basic Line Module a cable
harness set is required, which is available under order number 6SL3366-2NG00-0AA0.
The steps for the installation procedure are numbered in accordance with the diagram.
1. Unscrew the 3 screws for the blanking plate.
2. Insert the Braking Module where the cover used to be and secure it using the 3 screws
3. Use the connecting cable in the cable harness set
4. Secure the connecting cable to the DC link with 2 screws (Braking Module connection)
CAUTION
The tightening torques specified in the table "Tightening torques for connecting current-
conducting parts" must be observed.
200
Remove the plate.
(from step 1).
(order number 6SL3366-2NG00-0AA0).
and 2 nuts (DC link connection).
Manual, (GH3), 10/2008, 6SL3097-2AE00-0BP3
Chassis power units