Steering Wheel Play Inspection - Suzuki Ignis Service Manual

3B1-28 ELECTRICAL POWER STEERING (P/S) SYSTEM

STEERING WHEEL PLAY INSPECTION

Check steering wheel for looseness or rattle by trying to move it in
its shaft direction and lateral direction.
If found defective, repair or replace.
Check steering wheel play, holding vehicle in straight forward con-
dition on the ground and with engine stopped.
If steering wheel play is not within specification, inspect as follows
and replace if found defective.
• Tie rod end ball stud for wear
• Lower ball joint for wear
• Steering shaft joint for wear
• Steering pinion or rack gear for wear or breakage
• Each part for looseness
Steering wheel play
"a": 0 - 30 mm (0 - 1.2 in.)
STEERING FORCE INSPECTION
1) Place vehicle on level road and set steering wheel at
straight-ahead position.
2) Check that tire inflation pressure is as specified. (Refer to
"TIRE PLACARD" on vehicle.)
3) Remove driver air bag (inflator) module referring to DRIVER
AIR BAG (INFLATOR) MODULE in Section 3C.
4) Start engine.
5) With engine idling, measure steering force by turning torque
wrench.
Steering force
: Less than 6.4 N·m (0.64 kg·m, 4.6 lb-ft)
6) Install drive air bag (inflator) module referring to DRIVER AIR
BAG (INFLATOR) MODULE in Section 3C.