Bump Stopper/Spring Upper Seat Check; Rear Suspension Fasteners; Wheel Disc, Nut And Bearing Check - Suzuki Ignis Service Manual

BUMP STOPPER/SPRING UPPER SEAT
CHECK
• Inspect for cracks, deformation or damage.
Replace any defective part.
[A] : 2WD VEHICLE
[B] : 4WD VEHICLE

REAR SUSPENSION FASTENERS

Check each bolt and nut fastening suspension parts for tightness.
Tighten loose one, if any, to specified torque referring to the figure
in "GENERAL DESCRIPTION" in this section.

WHEEL DISC, NUT AND BEARING CHECK

• Inspect each wheel disc for dents, distortion and cracks.
A disc in badly damaged condition must be replaced.
• Check wheel nuts for tightness and, as necessary, retighten
to specification.
Tightening torque
Wheel nuts (a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
• Check wheel bearings for wear. When measuring thrust
play, apply a dial gauge to spindle cap center (2WD) or axle
shaft center (4WD).
Thrust play limit
"a" : 0.1 mm (0.004 in.)
When measurement exceeds limit, replace bearing.
REAR SUSPENSION 3E-5