Handoff Test; Short Message Service Test - Huawei Airbridge BTS3606E Commissioning Manual

Airbridge BTS3606E&3606AE
System Commissioning Guide
Step 4 Check that all calls are successful.
Step 5 Check that the calls are normal and voice quality is good.
----End

3.6.4 Handoff Test

The test procedure is as follows:
Step 1 Register two test CDMA MSs in the HLR.
Step 2 Power on the two MSs so that they are attached to the network and they switch to idle mode.
Step 3 Make a call in one sector to set up the conversation between the two MSs.
Step 4 Maintain the call and move one MS to the destination sector.
Step 5 Check that :
----End

3.6.5 Short Message Service Test

The test procedure is as follows:
Step 1 Register two test MSs in the HLR.
Step 2 Power on the two MSs so that they are attached to the network and they switch to idle mode.
Step 3 Send a short message from MS A to MS B.
Step 4 Check that:
----End
Issue 02 (2006-10-10)
Make a call from one MS to a PSTN subscriber and hook on after the conversation.
Make a call from a PSTN subscriber to one MS and hook on after the conversation.
Soft handoff refers to a handoff between different cells operating at the same frequency. Softer
handoff refers to a handoff between different sectors operating at the same frequency and in the
same cell.
One cell may contain one or more sectors. This test is relevant when multiple sectors are planned.
The call is maintained and stable.
Voice quality is good.
Ensure that the network is configured with a message center (MC).
MS A displays a prompt that the short message is sent successfully.
The message can be queried on the MC.
MS B receives the message and displays the messages correctly.
Huawei Technologies Proprietary
3 Commissioning Process
3-29