Communication - ABB Navigator 550 Operating Instructions Manual
Hydrazine analyzer, measurement made easy
Hide thumbs
Also See for Navigator 550:
- Manual (9 pages) ,
- Commissioning instructions (8 pages) ,
- Replacement procedures (8 pages)
Table of Contents
Advertisement
Navigator 500
Hydrazine analyzer
7.1.8 Communication
Menu
Communication
Select
Exit
Menu
Profibus
Slave Address
Baud Rate
Ethernet
DHCP
IP Address
Subnet Mask
Default Gateway
Email
SMTP Server ID
Recipients
Email Address 1 – 3 Enter the email address(es) of the recipient(s).
Triggers
Tag 1 – 4
Source 1 – 4
Invert 1 – 4
50
The Communication level is enabled only if an optional communications module is fitted.
Ethernet and Email menus are enabled only if a Ethernet communications module is fitted.
Comment
Sets the device-specific slave address for identification on the network.
A read-only value (range 0 to 12000 K) taken from the PC the network
is connected to.
Sets DHCP (Dynamic Host Control Protocol) on / off.
Set to On if the IP address is to be allocated dynamically by the
network.
Set to Off if the IP address is defined statically.
Sets the IP address to be assigned to the wet-section. The IP address
is used by the TCP/IP protocol to distinguish between different
devices.
The address is a 32-bit value expressed with 4 values (0 to 255), each
separated by a period (.).
Note. Configurable only if DHCP is disabled.
The subnet mask is used to indicate which part of the IP address is
used for the network ID and which part is used for the host ID.
Set each bit that is part of the network ID as '1's, for example:
255.255.255.0 indicates the first 24 bits are for the network ID.
Sets the IP address for the Default Gateway (router or switch) used to
communicate with other networks.
Note. This setting is required only if a router (or switch) is used.
The IP (Internet Protocol) address of the SMTP (Simple Mail Transport
Protocol) server used to distribute emails.
The trigger description that appears in the subject title.
Up to 4 independently-configurable triggers can be enabled to
generate an email when the selected source becomes active (the email
can be sent to up to 3 recipients).
If enabled, an email is generated when the Source becomes inactive
instead of active.
Default
000.000.000.000
OI/AHM550–EN Rev. A
Advertisement
Table of Contents
