Installing Epson Rc+ Software - Epson RC520 Safety And Installation

3. First Step
NOTE
Settings at Shipment
The RC520 robot controller is configured at factory as shown below:
User name and the password for Auto Log In
Windows Administrator Password
* The password is case-sensitive.
For details of other settings at shipment, refer to Appendix A Settings at Shipment
in the EPSON RC+ User's Guide.

3.2 Installing EPSON RC+ Software

EPSON RC+ is installed at the factory before shipment with the specified
configuration. However, if you need to add an option, upgrade, or re-install, refer
to the section Installing EPSON RC+ Software in Appendix A for instructions on
installing EPSON RC+.
Installing the software options key
Included with the EPSON RC+ Software is a software key device that enables
options. Without this device, the options you have installed will not be enabled.
All options are enabled on one key. Options can also be enabled in the field.
See the chapter Installing Options for details.
The software options key is installed
by simply plugging the male end of the
key into the parallel port connector on
the PC Control Unit.
Do not plug the options key into the
Option Device connector or any other
port other than the parallel port.
Permanent damage can occur.
PC Configuration
Refer to Appendix A and configure Date, Time, and screen resolution.
48
Log In User Name : EPSON RC User (with Administrator authority)
Log In Password : epson
Administrator Password : epson
RC520 Safety and Installation Rev.2