Conference; To Switch A Call With Transfer Key - NEC DT830 Series User Manual

To Bridge Into A Dial Intercom Call
Note:
Bridging is an optional feature.
STEP 1: Press the DICM key, lift handset or press
Speaker
key.
OVERRIDE
1:25 PM
STEP 2: A three-party conference is established.
CONF
1:25 PM
Note: Dial intercom provides a Dial Intercom group
where each member of the group may be called
by a 1-digit or 2-digit number without using their
prime lines.
Overriding party
3
MON 11 MAY 2015
MON 11 MAY 2015

CONFERENCE

STEP 1: With a call in progress, press
dial desired number.
STEP 2: After call is answered, press the Conf. soft
key. Three-way conference is established.
CONF
1:25 PM
Mic
STEP 3: If one party hang up, other two remain con-
nected. The Conf key's LED goes out.
Note:
The Conf key is accommodated on only DTZ-2E-
3 and DTZ-6DE-3. If using the terminals without
Conf
feature key to which conference feature has been
assigned.
TO SWITCH A CALL WITH TRANS-
FER KEY
DT830 DT430/410
STEP 1: While engaged in a call and wishing to con-
sult a third party, press
inal caller is automatically placed on hold.
STEP 2: Dial desired party to consult.
STEP 3: Press
Transfer
Third party is automatically placed on hold.
STEP 4: By repeating these steps, it is possible to al-
ternate between calls. The display indicates
connected station or trunk any given time.
137
DT830 DT430/410
Transfer
MON 11 MAY 2015
>>>
key, use a soft key or programmable
key. The orig-
Transfer
key to return to original caller.
key and