Installing A Host Connector - Hitachi AMS 2000 Series Service Manual

Installing a host connector

Complete the following steps to install a host connector.
CAUTION! After removing a host connector, wait at least 20
seconds before reinstalling it or installing a new one.
1. Check the insertion direction of the host connector and insert the host
connector into the part as far as you can.
2. Lift the host connector lock upward and inward until it clicks, locking the
host connector to the base unit.
NOTE: If using an 8 Gbps interface board (DF-F800-DKF84), insert the 8
Gbps host connector to the 8 Gbps interface board (DF-F800-DKF84).
3. Connect the fibre channel cables. Ensure that the cable retainer locks in
place. Pull gently on the connector to make sure that the cables are
secure and cannot be removed accidentally.
4. Observe the port LED and verify that it is ON. If it is not ON, there may
be other failures.
Table 4-16: Fibre Channel Port LED
Replacing parts
Hitachi AMS 2000 Family Storage System Service Guide
Item Description
1
Fibre Channel Port LED
4–33