Disconnecting The Fibre Channel Interface Cable - Hitachi AMS 2000 Series Service Manual

Disconnecting the Fibre channel interface cable

Complete the following instructions to disconnect a fibre channel interface
cable from the host connector on the control unit.
NOTE: If the connector is tight in the socket and cannot be easily
removed, do not pull hard on it to remove it. Instead, gently wiggle the
cable out of the socket on the host connector.
1. Remove the clamps (1) holding the Fibre channel cables to the rack.
2. Disconnect the Fibre channel cable retainer (2) from the cable.
3. Pull the cable out of the host connector.
5–8
Figure 5-4: Disconnecting Power Cables from a Rack
Maintenance
Hitachi AMS 2000 Family Storage System Service Guide