Hitachi AMS 2000 Series Service Manual page 68

Fibre channel host connectors
Each of the two AMS 2100 control units has two fibre channel data ports
(total of 4 ports per array). Each of the two AMS 2300 control units has four
fibre channel data ports (total of 8 ports per array). Each data port is part
of a removable/replaceable optical transceiver called a Host Connector.
Figure 1-25
an AMS 2300 control unit.
• Photograph
and the unit ready for removal. The second connector is shown capped,
as all of the host connectors are when the array is shipped. The third
and fourth ports are shown connected. Note that two types of fibre
channel cables and connectors are used in this photo.
• Photograph
data port.
• Photograph
array.
• Photograph
array. The front bezel key is included in the photo to show the relative
size of a host connector.
See the Hitachi AMS 2100/2300 Service Guide for information on removing
and replacing a host connector.
1–28
shows the four Fibre Channel data ports / Host Connectors on
1
shows the leftmost host connector with the lock opened
2
shows a close up view of the two connectors in each
3
shows a host connector partially removed from the
4
shows a host connector completely removed from the
Figure 1-25: Fibre Channel Host Connectors
Introduction
Hitachi AMS 2000 Family Storage System Service Guide