Huawei FusionModule2000 V500R003C10 Maintenance Manual page 92

FusionModule2000 Smart Modular Data Center
Maintenance Guide

If the iBOX is damaged, hold down the networking switches on all the iBATs managed by
the iBOX to clear present network parameters.

If the iBOX is not damaged, hold down the iBOX networking switch to clear present
network parameters.
Step 2 Disconnect cables from the iBOX and label the cables.
1.
2.
3.
4.
Figure 5-42 Disconnecting cables from the iBOX
Step 3 Remove the iBOX.
Figure 5-43 Removing an iBOX (from a battery cabinet)
Issue 04 (2020-01-03)
Disconnect the cable from the PoE port.
Disconnect the cable (if there is any) from the COM port.
Disconnect the cable (if there is any) from the BCB port.
Disconnect the cable from the HALL current monitoring port.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
85