Panasonic ISE SMART CONNECT KNX Product Manual page 18

Mounting and connecting the device
1. Snap the device vertically onto the top-hat rail (installation position: network connections at bot-
tom).
2. Connect the KNX/TP bus line (referred to below as the bus line) to the KNX connection of the
device (see figure 8 item 1) by means of the supplied bus connection terminal (see figure 8 item
2). Polarity: left/red: "+", right/black "–":
a. Attach the bus connection terminal (see figure 8, item 2).
b. Route the bus line with the sheathing intact until it is close to the bus connection terminal.
c. Firmly press the bus line into the bus connection terminal as far as possible.
d. Route the bus line to the back.
Figure 8: Connect the bus line
3. Connect the external power supply to the power supply terminal (see figure 9 item 1) by means of
the supplied power connection terminal (see figure 9 item 2). Polarity: left/yellow: "+", right/white:
"–".
a. Attach the power connection terminal (see figure 9, item 2).
b. Route the power line with the sheathing intact until it is close to the power connection termi-
nal.
c. Firmly press the power line into the power connection terminal as far as possible.
d. Route the power supply line to the back.
Figure 9: Connect the power supply
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
Installation
1-000C-000
S. 18 / 69