Table of Contents
Advertisement
APP
Correct operation
(off)
(green)
Error
(off)
...
...
...
...
(off)...(green)...(off)...(green)...
Slow flashing (about 1 Hz)
...
...
...
...
(off)...(green)...(off)...(green)...
Slow flashing (about 1 Hz)
.
.
.
.
.
(off).(green).(off).(green).(off).(green)
Rapid flashing
...
...
...
...
...
...
...
...
(off)...(green)...(off)...(green)...
(yellow)...(off)...(yellow)...(off)...
Slow flashing (about 1 Hz) in an alternating pattern
Table 7: Device status – Device starting up
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
COM
Device starting up.
(yel-
low)
Device booted up and ready for operation.
(yel-
low)
No power supply.
(off)
• Check the connections and the power sup-
ply.
(yel-
The device is fully started up but is not yet
low)
configured. The system is configured S
mode.
• Configure the device in the ETS.
The device is fully started up but is not yet
(off)
configured. The system is configured S-
mode.
• Configure the device in the ETS.
Connection to KNX is interrupted.
• Check whether the KNX and voltage con-
nections are mixed up.
• Check the bus connection.
• Check whether the power supply is cor-
rectly connected.
The firmware cannot be started.
(off)
• Please contact support.
The newly loaded firmware cannot be started.
The system is trying to activate the previous
firmware (invalid firmware).
• Please contact support.
Commissioning and configuration
Description
1-000C-000
S. 26 / 69
Advertisement
Table of Contents
