Panasonic ISE SMART CONNECT KNX Product Manual page 31

Setting the IP address, IP subnet mask and standard gateway address
1. In the ETS, select the device in your topology.
2. Under <<Properties>> select the <<IP>> tab.
3. You will find the available selection options in figure 18 and table 11, Settings for manual IP
address entry or for receiving automatically, p. 31.
Figure 18: IP settings
Setting
Receive IP address
automatically
Use a permanent IP
address
Table 11: Settings for manual IP address entry or for receiving automatically
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
The address data are automatically obtained from a DHCP server on
the data network.
The DHCP server must assign a valid IP address to ISE SMART CON-
NECT KNX Panasonic.
If you wish to contact a TV device via a host name, the
DHCP server must report a DNS server that can resolve
this host name.
If there is no DHCP server available, the device starts up
after a waiting time with an automatic IP address in the
address range of 169.254.1.0 to 169.254.254.255. As
soon as a DHCP server is available, the device is automati-
cally assigned a new IP address.
Enter the data manually
You can obtain the permitted IP address range and the subnet mask
and standard gateway from the router configuration interface.
Commissioning and configuration
Description
1-000C-000
S. 31 / 69