Panasonic ISE SMART CONNECT KNX Product Manual page 56

Table of Contents

Problem

Switching on takes a long time

Device is not switched on

Table 37: Switching on

Problem

Text is not displayed

Table 38: Screen texts

Problem

Status does not return a value Error code: GetState

Table 39: Status

ISE SMART CONNECT KNX Panasonic

The Wake on LAN function is not available for up to 30 sec-

onds after switching off the TV device.

Cause: Incomplete configuration of TV device

Solution:

• Switch the TV on using the remote control.

• Configure the following settings under <<Menu/Network/

TV remote settings>>:

– TV Remote = on

– Networked Standby = on

Troubleshooting

Cause: A link with the configured number does not exist (only

numbers 0-9 are valid).

Solution:

• Check the available numbers (ETS tab <<Screen texts>>).

• Enter the number of the desired text as the value of the commu-

nication object 30 | 130 | 230 | 330.

►

See Text selection, p. 53.

You will not receive an error message if you have not entered any

text under <<Screen texts>>.

Cause: The TV device not contactable.

Solution: Wait 10 seconds and then check whether the

TvComm error code is present. If the status value is still not

sent, switch the TV device off for ten seconds.

Troubleshooting

1-000C-000

S. 56 / 69

Table of Contents