Chapter 2 Preparations
1.6
Processor(CPU)
You can configure the multi-processor system by adding an optional processor.
1.6.1
Installation
Follow steps below to install the processor.
1.
Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the DUCT which cover CPU.
3.
Check the position of a CPU socket where a processor is installed.
4.
Push down the socket lever once to unlatch it from the hook, then slowly open the lever until it stops.
50
You must avoid static electricity to work with the procedure below. For details,
Important
refer to Chapter 2 (1.2 Anti-static Measures).
Make sure to use the processor authorized by NEC. Installing a third-party
processor may cause a failure of the processor as well as the motherboard.
Repair of the server due to failures or damage resulted from installing such a
processor will be charged.
Please check available CPU so that CPU of a different frequency isn't
intermingled.
When adding CPU, please change the installing point of a installed memory. For
details, refer to Chapter 2 (1.7 DIMM).
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
CPU #2
CPU #1