Installation - NEC Express5800/E120d-1 User Manual

Chapter 2 Preparations
1.7.4

Installation

Install a DIMM by using the following procedure.
1. Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Push the DIMM straight into the socket.
When a DIMM is inserted into the socket,
the lever automatically closes.
3. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
4. Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to Chapter 3 (2.BIOS Setup Utility (SETUP)) for BIOS Setup
Utility.
5. Run BIOS Setup Utility, and select Memory Configuration and then Memory Information from the
Advanced menu. Make sure the capacity of added DIMM is displayed properly.
Refer to Chapter 3 (2.BIOS Setup Utility (SETUP)) for BIOS Setup Utility.
6. Select Memory Configuration from the Advanced menu, and then specify Yes for Memory Retest.
After that, select Save Changes and Exit to reboot.
 Make sure the direction of the DIMM. The DIMM has a notch,
Important
preventing being incorrectly inserted.
 Do not apply too much pressure when pushing a DIMM into the
socket. Doing so can damage the socket or terminal part.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
Notch
Key
59