Link/Act Led ( 1, 2); 4.6.4 Disk Access Led; Uid Led (Id) - NEC Express5800/E120d-1 User Manual

Chapter 1 General Description
4.6.3 LINK/ACT LED ( 1,
LINK/ACT LED on front panel indicates the status of LAN port.
LINK/ACT LED
On (green)
Flashing (green)
Off

4.6.4 DISK Access LED (

DISK Access LED indicates the status of HDDs.
DISK Access LED
On (green)
On (amber)
Flashing green and amber
alternately.
(only when RAID system is
configured)
Off

4.6.5 UID LED (ID)

UID LED is provided one each at the front and rear of the server. If you press UID Switch provided at the front
or rear of the server, the light turns on. If you press it again, the light turns off. It flashes when commands from
software are received. This LED is used to identify the target server among multiple servers installed in a rack.
Especially when performing maintenance from behind the server, lighting the LED will help you to identify
which server to work with.
UID LED
On (blue)
Off
2)
Description
The server is connected with network normally.
The server is accessing network.
The server is disconnected from network.
)
Description
Hard disk drive is being accessed.
Hard disk drive is failing.
Rebuild is in progress.
Hard disk drive is halted.
Description
The UID switch is pressed.
The UID switch is not pressed.
Tips
You can turn on an LED using remote management software.
Express5800/E120d-1 User's Guide
4. Names and Functions of Parts
Solution
–
Contact your sales representative.
–
–
39