Chapter 2 Preparations
7.
Make sure that the slot cover which have been removed, tool, and/or screws are not left inside the
server. Then, reassemble the server.
8.
After installation, some server needs configuration for COM port by BIOS Setup Utility. Configure the
COM port according to the User's Guide.
The example of setting the device to need setting is described as follows.
a. Power on the server. Press F2 on POST screen to start BIOS SETUP.
b. Select [Advanced] [Serial Port Configuration], and set [Serial Port B] to [Enabled].
When [Enabled] is set, [Base I/O Address] and [Interrupt] menus are displayed.
The factory-set values are shown below.
74
Base I/O Address
: 2F8
Interrupt
: IRQ 3
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices