NEC Express5800/E120d-1 User Manual page 67

Chapter 2 Preparations
Connect another end of SAS/SATA cable that has been connected to connector (Ports 4-7) on
RAID Controller, to the connector on backplane.
8. Connect the PCI riser card to the
motherboard slot and fix the card with the
screw.
When connecting the card, position the
terminal part of the PCI riser card to the
slot on the motherboard and insert it.
9. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
(2) When using the optional RAID controller (N8103-152)
For details, refer to the manual that comes with optional RAID Controller (N8103-152).
When installing more than 5 Hard Disks, K410-269(00) Intaernal SAS/SATA cable of an option is needed.
Screw
 You must avoid static electricity to work with the procedure below. For
Important
details, refer to Chapter 2 (1.2 Anti-static Measures).
 Do not change the mode to hibernate while building a RAID System.
 When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
 When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
Ports 4-7
"Optional cable"
Standard cable
Ports 0-3
67