Chapter 3 Setup
1.
Turning on the Server
Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1.
Turn on the peripheral devices and display unit.
2.
Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, logo appears on the display.
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware. For
details, refer to Chapter 3 (1.1 POST).
Do not power on the server before amber POWER LED is unlit.
Tips
Wait for at least 30 seconds before turning on the server after turning off the
server.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
POWER LED
Express5800/E120d-1 User's Guide
POWER Switch
1. Turning on the Server
95