Using The Starter Control Panel (Motor Rotates); Loading The Project To The Drive Unit - Siemens SINAMICS S120 Getting Started

Using the STARTER Control Panel (Motor Rotates)

4.2

Loading the project to the drive unit

To load the project to the drive unit, proceed as follows:
1. If you have not yet opened "Project_2" (created in Chapter 3) or "Project_1"
(created in Chapter 5) in STARTER, open the project by choosing Project >
Open.
2. To use the "control panel" function, you have to switch to ONLINE mode. To
switch to ONLINE mode, press the function key Connect to target system (as
shown in Fig. 4-1).
3. To load the project to the drive unit, press the function key Load project to tar-
get system.
4. Save the configuration by choosing
Copy RAM to ROM.
Fig. 4-1
Note
When loading the project, note the LEDs on the control unit. The control unit is
ready for operation when the LED RDY is continuously lit (green).
4. Save the configuration and parameters in the drive unit by choosing Copy RAM
to ROM.
4-50
Project navigator with SINAMICS_CU320
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
2. Press the function key
Connect to target system
3. Then press the function key
Load project to target system.
 Siemens AG, 2004. All rights reserved