NEC Express5800 Series User Manual page 126

Chapter 3 Setup
5. If Property is selected, the following screen is displayed. On this screen, specify whether to use DHCP
and if DHCP is not used, configure IP Address/Subnet Mask.
6. Connect the LAN cable to the management LAN connector in order to connect to the network. It will be
available for use if you access EXPRESSSCOPE Engine 3 via Web browser from PC for management
according to the setting.
126
Tips
If Shared BMC LAN is enabled, Web feature, remote media/KVM feature, or
command line interface feature may be interrupted. In this case, wait for a while,
and connect with network again.
Express5800/R110e-1E User's Guide
3. EXPRESSSCOPE ENGINE 3