Installation - NEC Express5800 Series User Manual

Chapter 2 Preparations

Installation

1.11.3
Install a riser card to a PCI card in the following procedure.
1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Refer to Chapter 2 (1.6 Removing the Top Cover) to remove the top cover.
3. Remove the screw securing the rise
card. Hold the both ends of the riser card
and lift it off.
4. Confirm the installation position with the reference to the table on the previous pages.
5. Remove the screw from the rise card and
remove the blank cover.
6. Install a PCI card to the riser card.
When installing the card, position the
terminal part of the PCI card to the riser
card slot and insert it.
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type (low profile or full-height type) which respective riser card
supports and the type of PCI card to be installed.
Note
Be careful not to contact with other parts.
Note
Keep the blank cover for future use.
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins
of electric parts installed on the card. Installing cards with dirt or oil can
cause malfunction.
Tips
If you have trouble installing the card, remove the card once and try again. If you
apply excessive pressure on the card, a PCI card or riser card might break.
Express5800/R110e-1E User's Guide
1. Installing Internal Optional Devices
PCIe#2
Low profile side
PCIe#1
Low profile side
83