Removal - NEC Express5800 Series User Manual

Chapter 2 Preparations

Removal

1.8.4
Remove a DIMM in the following procedure.
1. Refer to steps 1 to 4 in Chapter 2 (1.3 Overview of Installation and Removal for preparations.
2. Lift the duct off the server.
3. Open levers on left and right sides of
DIMM slot to unlock DIMM.
4. Remove DIMM by pulling it up straight.
5. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
6. Confirm that no error messages are displayed on POST. If any error message is displayed, refer to
Chapter 3 (1. Post Error Message) in "Maintenance Guide".
7. Run the SETUP utility, select Memory Configuration from the Advanced menu, and then specify Yes
for Memory Retest. After that, select Save Changes and Exit to reboot.
8. Set the paging file size to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, consult the manual provided with the operation system or contact the store where you
purchased it or your maintenance service company.
58
Note
• When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is
installed.
• At least one DIMM needs to be installed for the server to operate.
Express5800/R110e-1E User's Guide
1. Installing Internal Optional Devices