NEC Express5800 Series User Manual page 84

Chapter 2 Preparations
7. Fix the PCI card with the screw you removed at step 5.
PCIe#2 Low profile side
8. Connect the riser card to the mother
board slot and fix the card with the screw
you removed at step 3.
When connecting the card, position the
terminal part of the card to the slot on the
motherboard and insert it.
9. Attach the removed components.
10. Turn on the server and make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
11. Start the BIOS Configuration utility installed on the mounted board to set up the board.
Availability or startup and operation procedure of the utility depends on board. For details, refer to the
manual that comes with the board. If a PCI card including RAID Controller, SAS controller, and LAN
card which connects to any bootable device is added, the boot priority might be changed to the default
setting. In that case, configure the boot priority in the Boot menu of the BIOS Setup utility. For details
about the Boot menu, refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".
84
Note
• Make sure that the head of a PCI card bracket is seated into the fixed slot.
• Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
Tips
If the cable which is to be connected to the connector on the motherboard of the
server is provided on the board, connect it to the board before installing the riser
card to the server.
Express5800/R110e-1E User's Guide
1. Installing Internal Optional Devices
PCIe#1 Low profile side