Rear View - NEC Express5800 Series User Manual

Chapter 1 General Description
4.3

Rear View

(1)
(1) AC Inlet
This socket is used to connect the power cord.
(2) Serial port A (COM A) connector
This connector is used to connect devices that support a
serial interface. Note that it is not possible to directly
connect to a dedicated line.
(3) LINK/ACT LED (green)
The LED indicates the access status of LAN.
(4) LAN connectors
1000BASE-T/100BASE-TX/10BASE-T supported LAN
connectors
If Shared BMC LAN feature is enabled in ROM Utility, LAN
connector 1 can also be used as the management LAN
port. However, sharing port is not recommended from the
point of performance and security, because LAN port 1 may
receive both data.
(5) SPEED LED (green/amber)
The LED indicates the transfer speed of LAN ports.
(6) Display connector
The connector to connect a display.
(7) DC Power LED (green)
This LED lights green when the power is ON.
(8) USB connectors
These connectors are used to connect devices that support
the USB interface.
(3) (4) (5) (3) (4) (5)
(2)
(6) (7) (8) (4) (9) (5) (10)
(9) Management LAN port
(10) UID (Unit ID) switch/LED (blue)
(11) PCI slot
Express5800/R110e-1E User's Guide
4. Names and Functions of Parts
(11)-1 (11)-2
LAN connector which supports
100BASE-TX/10BASE-T.This port cannot be used as a
data transmission port. This port is used for connecting to
EXPRESS SCOPR ENGINE 3. This port is disabled when
Shared BMC LAN feature is used.
The switch to turn on and off the UID LEDs provided at the
front and rear of the server. Pressing the switch once turns
on the UID LED and pressing once more turns off the LED.
The slot is used to install the low profile type PCI board.
The sequential numbers indicate the corresponding slot
numbers.
35