ANG=...
X... Z... ANG=...
● Rounding as transition between the straight lines:
ANG=... RND=...
X... Z... ANG=...
● Chamfer as transition between the straight lines:
ANG=... CHR=...
X... Z... ANG=...
Programming of the end point of the first straight line by specifying the coordinates
● Corner as transition between the straight lines:
X... Z...
X... Z...
● Rounding as transition between the straight lines:
X... Z... RND=...
X... Z...
● Chamfer as transition between the straight lines:
X... Z... CHR=...
X... Z...
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Fundamentals
2.9 Motion commands
215