Drills - Siemens SINUMERIK 840D sl Programming Manual

T
T'
L1
R
L1'
L2'
L3'
Tool parameters
$TC_DP1
$TC_DP3
$TC_DP6
$TC_DP21
$TC_DP22
$TC_DP23
● Wear values corresponding to the requirements.
● Other values should be set to 0.
2.5.5.3

Drills

The following tool types are available in the "Drills" group:
No.
200
205
210
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Tool carrier reference point
Tool carrier reference point
Geometry - length 1
Tool radius
Base dimension - length 1
Base dimension - length 2
Base dimension - length 3
Meaning
Tool type
Geometry - length 1
Geometry - radius
Base dimension - length 1
Base dimension - length 2
Base dimension - length 3
Tool type
Twist drill
Drill
Boring bar
Fundamentals
2.5 Tool offsets
73