Toshiba Strata DK 16 Installation And Maintenance Manual page 305

STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 53
Press CR.
3 Define Route Plan Number
Refer to the System Record Sheet and enter the route
plan number (1 ~ 8).
Example: Route Plan 1, enter 1.
4 Define Schedule Number
Refer to the System Record Sheet and enter the required
schedule number (1 ~ 3).
Example: Schedule 1, enter 1.
5
Enter Code Number 0
The system will display the previously selected time for
the route plan number (step 3) and the schedule number (step 4).
Refer to the System Record Sheet and change the time if required.
Example: Change to 0800. Enter 0 8 0 0.
Press CR and repeat steps 3, 4, and 5 for all plans/schedules.
NOTE: Enter time using 24-hour format: H H M M.
6
Priority Class Assignment
Enter the route plan number as defined in step 3.
Enter the schedule number as defined in step 4.
Refer to the System Record Sheet and enter the required
station group number (1 ~ 4).
Example: Group 1, enter 1.
The system will display the previously entered route definition
numbers (reference
Refer to the System Record Sheet and enter required
route definition numbers (1 ~ 4) and press CR.
Example: Enter 1 and 2 CR.
Continue to repeat steps 3, 4, and 6 until all plans/schedules
are entered.
7 To Exit Program/Store Data
Data was stored when pressing CR in step 6.
A)
B) Continue returning to step 3 until all data is entered
for this program.
C) To exit this program.
Press # # CR.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-BF
PROGRAM 53
LCR SCHEDULE ASSIGNMENT
ACTION
Program 54 ).
-55-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE PROG
P
P 53
P53
P53 1
P53 11
P53 110 0000 0800
P53
P53 111 NNNN 12
P53
P53 ##
P