Toshiba Strata DK 16 Installation And Maintenance Manual page 312

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
REMOTE CALLING STATION MESSAGING (ADD/REVIEW/CHANGE)
STEP
1 Enter the Message Mode
At the >MODE prompt, enter M E S G CR.
2 To Add Or Review a Calling Station Message
Set the terminal keyboard to the lower case (cap lock off) and
enter m 9 5.
NOTE:
Enter "m" anytime it is desired to start over in this procedure.
Enter X X X (XXX = station number where the message will be
3
set and stored).
4 Enter p (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system message).
NOTES:
1. To store system messages permanently, DKT or EKT XXX
must be the station at port 00.
2. After p is entered, the previously stored message is
displayed. If there is no stored message, nothing is displayed.
5 To Change Previous Message
Set the terminal keyboard to upper case and change message
(alphanumeric, 32 characters max.).
6 To Set the Message on DKT or EKT XXX's LCD
Set the terminal keyboard to lower case and enter p m 0.
7 To Exit the Message Mode
At any time, enter m 0 q (lower case).
NOTES:
1. To cancel a message set via Mode 95, use Mode 97 procedure.
2. [M] represents the message entered.
3. DKT = digital telephone; EKT = electronic telephone.
TABLE RM-BO
MODE 95
ACTION
-62-
DISPLAY/PRINTOUT
>MODE MESG
m 95
m95 XXX
m95 XXX p [M]
m95 XXX p [M+]
m95 XXX p [M+] p
m 0
Zero
m 0
q
> MODE