Toshiba Strata DK 16 Installation And Maintenance Manual page 319

STEP
1 Enter the Speed Dial Mode
At the >MODE prompt, enter R E P T CR.
2 Enter the station port number for which the speed
dial number will be programmed
Press
(00 ~ 19)
NOTE: If programming system speed dial, enter
port number 0 0.
3 Enter Speed Dial Memory Location to be Programmed
A) Press
10 ~ 49 Station
60 ~ 99 System
B) Press SPACE to review each memory location or go to Step 4.
4 1) To enter speed dial number (20 digits max)
20-digit number
Press . . . . . . . . . .
2) To enter chain dial number
17-digit number
Press A . . . . . . . . . . . .
System speed dial location (90 ~ 99)
(Refer to Digital or Electronic Telephone User Guide for
information regarding chain dialing.)
Special Entries: F=Flash; P=1.5 or 3-sec Pause (Prog. 12);
L=10-sec Pause; N=Clear Memory.
Special code entry: I = Intercom
To store data, press CR
5
NOTE: If program entry is not correct, CR will not
respond. To try again, press DELETE CR at the same time.
6 To Exit the Speed Dial Mode
Press Q U I T CR.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-BW
SPEED DIAL MODE (CHANGE/REVIEW)
ACTION
(current memory will display)
H = Hold
C = Conference
>MODE REPT
R
R
Memory
location
R
R
>MODE
-69-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
Station Port Number
N
Nothing in
memory
N
. . . . . . . . . .
New speed dial number