Dk8 And Dk16 Pdiu-Di/Pdiu-Ds Sw1 Dip Switch Information - Toshiba Strata DK 16 Installation And Maintenance Manual

PDIU-DI (BOTTOM VIEW)
DIRECTORY TRAY:
REMOVE FROM ORIGINAL
TELEPHONE BASE AND
INSTALL ON PDIU-DI BASE
PDIU-DI DIGITAL TELEPHONE BASE
NOTES:
1. DIU port must have
LED 02 ON in Program 20
to enable auto disconnect.
2. See Paragraphs 10.20
and 10.30 for more details
regarding SW1 option
settings.
3. When a PDIU-DS is connec-
ted to a modem that tracks
the DCD signal (AT&C1)
SW1(4) must be ON.
4. If using Toshiba Personal
Computers and Toshiba
Printers using X-ON/X-OFF
flow control, set SW1(4) ON
on PDIU-DIs and -DSs.
5. SW1(2) should be off when
PDIU-DS is connected to a
modem.
FIGURE 7-32

DK8 AND DK16 PDIU-DI/PDIU-DS SW1 DIP SWITCH INFORMATION

DIP SWITCH
PDIU-DS (REAR VIEW)
DB25 CONNECTOR (FEMALE)
FOR DTE OR DCE RS-232
CABLE CONNECTION
PDIU-DI AND -DS SW1 DIP SWITCH (1 ~ 4) FUNCTIONS
SWITCH FUNCTION
SW1 Forced hang up when DIU does not
(1) detect space signal on TD or RD for
about 9 minutes
ON: enable (auto-disconnect) 1
OFF: disable
SW1 DCD, DSR control
(2)
ON: continuous on
OFF: DSR depends on DTR
(DCD is on during
communication state)
SW1
RI control
(3)
ON: RI is on continuously during
ringing state
OFF: RI is 1 sec ON/3 sec OFF
during ringing state
RTS control
SW1
ON: DTE doesn't have RTS signal
(4)
OFF: DTE has RTS signal (ready/busy
flow control: RTS/CTS:DCD)
7-49
INSTALLATION-PERIPHERALS
ACCESS FROM BOTTOM
— OUTSIDE OF PDIU-DI
DIP SWITCH SW1 BACK VIEW
(ACCESS FROM BACK
— OUTSIDE OF PDIU-DS)
1 2 3 4
DNTA
MODULAR
CONNECTOR FOR
DIGITAL PORT
CONNECTION
SECTION 100-816-207
MARCH 1993
INITIAL
POSITION
OFF
OFF
OFF
OFF