Installing An Ibox - Huawei PowerCube 5000 Installation Manual

PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Figure 4-5 Installing a GIM01C
----End

4.6 Installing an iBOX

Prerequisites
Procedure
Step 1 Connect the antenna provided with the iBOX to the RF_Z port on the iBOX.
Step 2 Attach the fastener to the wall.
Step 3 Clamp the iBOX to the fastener.
Issue 03 (2020-04-10)
 There should be no other wireless devices such as ZigBee, Bluetooth, WiFi, or wireless base station
devices in the battery room.

The iBOX should be no more than 10 m away from the farthest end of the battery rack.
 The iBOX needs to be installed above one end of the battery rack.
 There should be no obstructions higher than the battery rack between the iBOX and iBAT.
 At least one side should be visible between the iBOX and the battery rack.

Before attaching the iBOX fastener, ensure that the installation surface is smooth and dustless.
 It is recommended that the iBOX be installed more than 1 m above the floor. Signals will be weak if
it is installed at a lower position.
 To avoid signal shielding, do not install the iBOX at a position with metal walls around it.
 The iBOX antenna should be perpendicular to the floor.
 Clearance should be kept around the antenna.
Copyright © Huawei Technologies Co., Ltd.
4 Installing Components
37