Installing A Dg Interface Module (Gim01C) - Huawei PowerCube 5000 Installation Manual

PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Figure 4-4 Installing the NIM01C3
----End

4.5 Installing a DG Interface Module (GIM01C)

If a GIM01C is required, perform the following steps to install it.
Procedure
Step 1 Put on an ESD wrist strap or a pair of ESD gloves.
Step 2 Install the GIM01C.
1.
2.
3.
4.
The GIM01C must be installed in the slot under the installation slot for the communications
expansion module. Otherwise, the GIM01C cannot work properly.
Issue 03 (2020-04-10)
Unscrew the filler panel and gently remove it from the slot.
Open the ejector lever on the GIM01C, put the GIM01C at the entry of the slot, and
gently push it in place.
Close the ejector lever.
Tighten the captive screws at both ends of the GIM01C panel to a torque of 0.6 N•m.
Copyright © Huawei Technologies Co., Ltd.
4 Installing Components
36