Installing An Isolation Transformer - Huawei PowerCube 5000 Installation Manual

PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
Figure 3-9 Installing the waterproof panel
----End

3.2 Installing an Isolation Transformer

Context
In this example, an 80 kVA isolation transformer is installed.
Procedure
Step 1 Unpack the isolation transformer.
Step 2 Mark the position of the cabinet based on the delivered marking-off template.
Step 3 Remove the blocking piece on the mounting hole of the isolation transformer base.
Step 4 Drill holes and install expansion sleeves.
1.
2.
3.
Issue 03 (2020-04-10)
Drill a hole into the concrete floor using a hammer drill. The hole depth should range
from 52 mm to 60 mm.
Slightly tighten the expansion bolt and vertically insert it into the hole. Knock the
expansion bolt using a rubber mallet until the expansion sleeve is fully inserted into the
hole.
Partially tighten the expansion bolt.
Copyright © Huawei Technologies Co., Ltd.
3 Installing the Cabinet
27