Huawei TP48200A-HT19C4-1 Installation Manual page 84

TP48200A-HT19C4-1 & TBC300A-TCA2
Installation Guide
Main Second-
Menu Level Menu
Step 3 Set the IP Addresses and Ports for the active and standby servers of the NetEco on the LCD,
as described in
Table 10-7 NetEco parameters
Main Second-
Menu Level Menu
Parameters Comm.
Settings Parameters
----End
Networking Mode 2: over RS485 Port
Step 1 Check that the following parameters are set properly: Port Mode to Manual, Protocol Type
to M/S Protocol, Baud Rate to 9600, and Comm. Address to 3.
Table 10-8 Communications parameters
Main Menu Second-
Level Menu
Parameters Comm.
Settings Parameters
----End
Issue 01 (2014-03-12)
Third-Level
Menu Default Value
Default Gateway 192.168.0.1
Table 10-7.
Third-Level Fourth-Level
Menu Menu
Network NetEco Primary IP
Parameters
NetEco Backup IP
NetEco Port
Number
Third-Level Fourth-
Menu Level Menu
Serial Port Northbound
M/S Protocol Northbound
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
Set this parameter according to
the gateway address provided by
the network administrator.
Default Value
192.168.0.10
192.168.0.10
31220
Fifth-Level Default
Menu Value
Port Mode Manual
Protocol M/S Protocol
Type
Baud Rate 9600
Comm. 3
Address
10 Commissioning
Setting
Set an IP address
for the active
NetEco server.
Set an IP address
for the standby
NetEco server.
Set a port for the
NetEco.
Setting
Manual
M/S Protocol
9600
3
77