Optional Equipment; Installing The Isolator Lead; Installing The Water Pressure Sensor - Yamaha F225F Service Manual

c

Optional equipment

Installing the isolator lead

1. Remove the cap a.
a
2. Connect the isolator lead coupler b.
b
a
b
TIP:
Pass the isolator lead a over the battery
cables b so that they do not cross over each
other.

Installing the water pressure sensor

See 6Y8 Multifunction Meter set up manual
for details of the components.
1. Remove the braided plug a and gasket
b.
Rigging grommet mounting / Optional equipment
b
b
b
a
2. Install a new gasket c and the adapter
d, and then tighten the adapter d to the
specified torque.
reuse a gasket, always replace it with
a new one.
c
d
Water pressure sensor adapter d:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
3. Install the water pressure sensor e, and
then tighten it to the specified torque.
e
Water pressure sensor e:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
4. Remove the water pressure sensor
harness a from the holder f.
5. Remove the water pressure sensor
coupler b from the bracket g, and then
remove the cap c.
Optional equipment
NOTICE: Do not
3-10
0
1
2
3
4
5
6
7
8
9
10
A