Assembling The Forward Gear; Assembling The Lower Case - Yamaha F225F Service Manual

LOWR
8. Hold the taper roller bearing outer race,
and then measure the motive torque of
the drive shaft.
Drive shaft motive torque:
0.27–1.94 N·m (0.03–0.20 kgf·m,
0.20–1.43 ft·lb)
9. Bend the tab h on the claw washer c to
secure the drive shaft nut d.
h

Assembling the forward gear

• Use heat-resistant gloves. Otherwise,
burns could result.
• To prevent fires, remove any flammable
substances, such as gasoline and oil,
around the working area.
• Keep good ventilation while working.
Do not reuse a bearing, always replace it
with a new one.
1. Heat the installation area of the roller
bearing in the adapter a using a gas
torch, and then install a new roller bear-
ing b. NOTICE: When heating the
adapter, heat the entire installation
area evenly. Otherwise, the adapter
could be damaged.
2. Install the dowel c.
8-27
Lower unit
d
c
c
3. Install a new taper roller bearing d and
the washer e, and then install the circlip
f.
f
e
d

Assembling the lower case

1. Install a new needle bearing a NOTICE:
Do not reuse a bearing, always
replace it with a new one.
a
b
a
Ball bearing attachment b: 90890-06655
Bearing outer race puller assembly c:
90890-06523
b
a
c
c
b
a