Removing The Drive Shaft; Removing The Reverse Gear; Disassembling The Oil Seal Housing; Disassembling The Drive Shaft - Yamaha F225F Service Manual

Removing the drive shaft

See "Removing the drive shaft" (8-23).

Removing the reverse gear

1. Remove the reverse gear a, thrust bear-
ing b, reverse gear shim c, and adapter
d.
a
b
c
d

Disassembling the oil seal housing

See "Disassembling the oil seal housing" (8-
23).

Disassembling the drive shaft

See "Disassembling the drive shaft" (8-23).

Disassembling the reverse gear

1. Remove the circlip a.
2. Remove the needle bearing b.
Drive shaft and lower case (counter rotation model)
Driver rod L3 c: 90890-06652
Needle bearing attachment d:
3. Disassemble the adapter. See steps 2

Disassembling the lower case

See "Disassembling the lower case" (8-25).

Checking the pinion

See "Checking the pinion" (8-25).

Checking the reverse gear

1. Check the teeth and dogs of the reverse

Checking the drive shaft

See "Checking the drive shaft" (8-25).

Checking the lower case

a
See "Checking the lower case" (8-25).

Assembling the drive shaft

See "Assembling the drive shaft" (8-25).

Assembling the reverse gear

Do not reuse a bearing, always replace it
with a new one.
1. Assemble the adapter. See steps 1 and 2
2. Install a new needle bearing a to the
c
d
90890-06653
and 3 in "Disassembling the forward
gear" (8-24)
gear. Replace if cracked or worn.
in "Assembling the forward gear" (8-27).
specified installation depth a.
d
c
b
8-78
0
1
2
3
4
5
6
7
8
9
10
A