Y-Cop - Yamaha F225F Service Manual

Y-COP

Y-COP consists of a transmitter and a receiver. The receiver transmits an authorization ID to the
Digital Electronic Control ECM. If an authorization ID is not received or if the transmitted authoriza-
tion ID does not match the registered ID in the Digital Electronic Control ECM, the receiver cannot
perform data communication with the Digital Electronic Control ECM. Pushing the lock and unlock
buttons on the transmitter causes the receiver to recognize the lock and unlock state, and to send
data to the Digital Electronic Control ECM. The locked or unlocked state is maintained even when
the battery switch is turned to off.
Y-COP
Transmitter
Receiver
Hub
Digital Electronic Control
ECM
6Y9 Multifunction Color
Gauge
State
Unlocked
Locked
Communication error, improper wiring
connection.
TIP:
• The receiver can register up to 5 transmitters.
• Additional transmitters cannot be registered if none of the transmitters is functioning properly.
• The transmitter and receiver function within a distance of approximately 3 m (10 ft).
• Installation location requires special attention to avoid electrical interferences, obstructions, or
water exposure.
Electronic control system / Y-COP
Engine
ECM
Normal
Stops fuel injection and ignition, and prevents
the engine from starting.
The engine will start, but engine speed is
limited to 2600 r/min.
Outputs a trouble code
Y-COP
Ignition coil
Fuel injector
Battery
Operation
0
1
2
3
4
5
6
7
8
9
10
A
2-22