POWR
Disassembling the cylinder block
1. Remove the crankcase a.
2. Remove the connecting rod caps a, and
then remove the crankpin bearings b,
connecting rods, and piston assemblies
c.
c
b
c
7-77
Power unit
a
a
b
b
TIP:
• To prevent mixing the pistons, connecting
rods, and connecting rod caps, mark each
with an identification number b of the cor-
responding cylinder.
• Mark each connecting rod and connecting
rod cap with mark c on the side facing
toward the flywheel magnet end of the
crankshaft.
• Make sure to keep the parts in the order of
removal.
3. Remove the crankshaft d, crankshaft
journal bearings e, thrust bearings f,
and oil seal g.
e
g
f
e
4. Remove the collar h.
h
i
k
j
d
e
f
e
d
e
k