Installing The Rectifier Regulator - Yamaha F225F Service Manual

POWR
e
d
a
c
Terminal bolt c:
25 N·m (2.5 kgf·m, 18.4 ft·lb)
4. Install the PTT relay leads a and b, and
then tighten the PTT relay lead nuts f to
the specified torque.
5. Install the starter motor lead c, and then
tighten the starter motor nut g to the
specified torque.
6. Install the caps d.
f
d
f
b
g
PTT relay lead nut f:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
Starter motor nut g:
9 N·m (0.9 kgf·m, 6.6 ft·lb)
7-29
Power unit
b
a
c

Installing the Rectifier Regulator

1. Install a new gasket a and the cover b,
and then tighten the Rectifier Regulator
cover bolts c to the specified torques in
2 stages. NOTICE: Do not reuse a gas-
ket, always replace it with a new one.
Rectifier Regulator cover bolts c:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
2. Install the Rectifier Regulator d.
d
3. Install the ground lead a.
4. Connect the cooling water hoses b and
c.
b
a
c
b a
c