Yamaha YZF-R1 Series Service Manual page 236

3
b
b. Make sure that the throttle grip "1" turns
smoothly.
c. Install the handlebar switch (right, rear
side) "4".
TIP
Align the projection "c" on the handlebar switch
(right, rear side) "4" with the hole "d" in the han-
dlebar "1".
1
c
d. Install the grip end (right) "5".
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "e" between the throttle grip and the grip
end.
2
a
b
1
a
1
d
4
5. Install:
• Front brake master cylinder assembly
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-61.
6. Install:
• Clutch lever holder "1"
• Clutch cable
Clutch lever holder pinch bolt
11 N·m (1.1 kgf·m, 8.1 lb·ft)
TIP
Align the center of slit on the clutch lever holder
with the punch mark "a" on the handlebar.
1
7. Install:
• Handlebar switch screw (left)
Handlebar switch screw
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
TIP
Align the projection "a" on the handlebar switch
(left) with the hole "b" in the handlebar.
4-87
HANDLEBARS
e
5
a